|
|
|
|
| |
|
1 |
To begin, remove the cover by pulling out on the
indentations found on the 48 inch side of the cover. Once the cover
is removed, simply unfold the two 48 inch sidewalls, followed by the
45 inch sidewalls. The walls will interlock in the corners and the
latch should snap in place (see blow-up illustration). |
|
|
|
2 |
(Optional) If you are using a woven liner make
sure the cut out for the bottom drain is aligned with the port on
the Arena 330 Shipper™. Drape the flaps over the side of the
container. If necessary, use a stick to square the woven liner on
the floor of the container. If you are using the corrugated or
plastic sheet liner, install as shown below. 
Woven
Liner
Corregated or Plastic Sheet
Liner |
|
| |
|
3 |
Remove a standard pillow or tray-fold cassette bag from its
shipping box and unfold (A). Attach the fill hose (B) and bottom
drain locator tool (C) to the liquid liner bag. It is easiest if you
use a "quick-connect adapter" between the hose and the bag. Lower
the hose/adapter/bag setup into the Arena 330 Shipper™ with the
bottom drain locator aligned with the port of the container.
Important!
DO NOT
REMOVE THE LIQUID BAG FROM THE CORRUGATED SHEET! Simply
lay the bag on the bottom of the container, making sure to align the
bottom drain with the port on the container. THERE IS NO NEED TO MANIPULATE THE BAG ONCE IT HAS
BEGUN TO FILL. IT WILL UNFOLD AUTOMATICALLY.
|
|
|
|
 |
A. Locate the
bottom fitting by pulling the strap through the port on the Arena
330 Shipper.
B. To lock the
fitting into place, slide the clip down. Remove the bottom drain
locator tool. You may now begin to fill.
 |
|
|
|
 |
Once the bag
has filled, removed the hose and adapter and replace the fill
fitting cap on the bag. [If you're using a woven liner, fold the
flaps in.] Place the cover on the container.
Pull down the latches (as indicated by the illustration) to
lock the cover in place. There are two latches on each side of the
container.
|
|
|
|
